HolaGrafiX™ Application Guide

---

HolaGrafiX™ may be applied over other colours or previously painted surfaces. For best results, scuff the surface and apply Diamond Clear™ to ensure a high gloss finish and allow to fully cure. Apply the HolaGrafiX™ using a IWATA HTE gun. After 2 hours, apply the Key Clear™ allowing 15 minutes between coats. Then apply your Diamond Clear™.

NOTE: Please refer to the full Technical Data Sheet (see PDF file before commencing any work)

Custom painting can be difficult. All products should be fully tested prior to commencing any job to determine suitability, final finish and overall appearance. All information and data provided by DNA™ is given in good faith and intended to be a general guide only. DNA™ shall not accept liability as a result of any failure or lack of expertise on the part of the applicator, condition of substrates, lack of, or incorrect preparation, use of incompatible materials, equipment failure or use of incorrect equipment or any other reason beyond the control of DNA™ and further offers no warranties of whatever nature express or implied as to merchantability or fitness for a particular use or purpose and shall not accept liability for any specific or consequential damage as a result of using these products unless otherwise agreed to in writing. Should a product be defective, DNA™ shall replace the defective product, or, at its sole discretion refund the purchase price.